Die Test was failing to stop the encoder simulation and halt until the Coast Mode Timeout expired. This was caused by SCN 4664 when the runtask was provided its own method for limiting material motion.

On the XL200CL-MRE2 the second die can be configured in multiple ways. The IO for the second die was being defined as if configured for the Shear Die. In most cases this would be OK except if the Shear Was defines as a Linear DA or an Eccentric DA. In this case a Press Up output was being configured.

This bug did not hurt anything but it did cause an undefined output in the IO diagnostic screen to turn on and off. This has been resolved.