Prior to SCN-2947, the Unload Coil Screen was displayed on Tail-In when the next coil was threaded. Any manual shear that occurred after a tail-out was tracked against the coil that just tailed out. When Eclipse is enabled, a Coil is required to allow manual shears.

Now that the Unload Coil screen is presented on tail-out, if the operator answers the question indicating they no longer have a coil loaded they are not allowed to do a manual shear until they thread the next one up and enter the coil number in. This prevents them from using the shear to make a good part out of the remaining scrap.

To counteract this new limitation the software has been modified to allow a manual shear against the previously loaded coil up until a new coil is detected by the sheet detect switch. They are then prevented from doing a manual shear until they enter a coil number into the load coil screen.