The Upper limit of the hole tolerance is changed from 5" to 10".

This change is to allow one customer who is trying to Hole Correct on holes that vary in size. There largest hole is 12 inches and they want to center the shear in the middle of the hole. They have to lie to the Shear to detect distance by 6" to get the shear to center cut the hole but this means that the hole is detected outside of our prior allowed 5" maxim tolerance.

A large Hole Tolerance allows a big opportunity for miss detected holes. A long term solution to the above stated problem should include a setup that allows an offset to be programmed to adjust for the size of the hole and where the detector will sense it based on which edge is being sensed. Another setting would include where, within the hole, the controller should cut.