The new screen is displayed if the controller is in Hole Correction mode.

The new screen currently shows three fields.

1. The controllers correction Factor is displayed.
2. The Hole Correction is displayed.
3. The Offset is displayed.

The Hole Correction will be 100% if the Shear targets being Queued using the controllers corrected resolution (Correction Factor). On Shear only applications where the controller is detecting holes put in by another system, the controller will have to correct the targets it queues to prevent them from drifting outside of the Hole Tolerance. It is assumed that the system placing the holes will be placing them correctly. In this case the Hole Correction is the percentage that the Targets are being adjusted by when being added to the Queue. This is a correction of the controllers correction factor.

The Offset is the difference between where the XL has its target queued and where the holes are being detected.