The error message "No material code programmed" displayed on a Multi-Axis machine even though the Order had a material code. After investigating, it was discovered that it was the coil that had no material. It checks the coil material because the material may have been overriden or substituted. We need to use the material properties of the actual coil not what the order calls for when settting up Axes for the machine. What it does is correct but the error message was incomplete and did not direct the user to check the coil material.

If Coil Inventory is turned OFF, the original error message is displayed.

If Coil Inventory is ON a new error message is displayed that directs the user to look at both the Order and Coil material. The reason for this is that the coil material some times getes set based on the Order material.