A Tool Axis may only be used by one press. Otherwise, the presses would fight over control of the axis. However, what actually happened is that each Tool Axis is assigned a Press ID that it uses to find its closest target in the queue. Since there can only be one press assigned, only one press would control the axis and all other targets would be ignored.

This has always been a limitation but there was no test to enforce it. This has now been resolved.

When entering the run mode, each of the Tool Axes will be tested to see if more than one press is configured to use it. If the condition is detected, an Error message will be displayed and the line will drop out of run.