For the XL200 Hump and Brake, the request for an output that turns on at a programable distance from the cut point was made.

A setup, called Cut Window Distance was added. It defaults to zero, which disables the feature. A non-zero value enables it. It is only active for the Open Loop XL200 Hump and Brake. It also must be configured for feed to stop operation.

The output is only active while in the Run Mode. This is due to the queue behavior on a Shear Only controller. The Queue, and hence the shear target, are only present while in Run Mode. The output should only be evaluated while in Run, once the motion outputs have been activated, so that the shear target is known to exist and has been processed.