On a tile machine Tools 1 is expected to be used for programming Tile Steps. When the machine is configured for dual forming presses, Tool 2 is reserved for the configuration of the second forming press. However, it must not be programmed in the pattern.

There was a test added to the part calculations that detected ths condition. The test displayed the wrong error message. It displayed an error message that is reserved for the Alternating Press option. In addition, the conditions when it would display the error were not correct either.

The test now only fails when the machine is configured for two forming presses.It also displays an error message to indicate Tool 1 is only to be used to configure Tile operations, not Tool 2.