The Windows simulation has a configuration used to test the PLC diagnostic screen. The Feed to Stop Shear Handshaking feature was active, preventing a shear operation when the PLC option was enabled and configured.

The feature has now been disabled in the configuration in the Windows simulation.

The Coil Inventory screen would delete a coil with no confirmation prior to this change. An "Are you sure?" window prompt will now be displayed, giving the user a chance to reconsider if they have hit the F3-Delete key by mistake.

More bug fixes found while testing Welded Coil Functionality

A request was made for separate Minimum Slow Distance settings applicable to the Short Part and Very Short Part settings.

There are two new settings, Short Part Min. Slow Dist. and Very Short Part Min. Slow Dist.. They have all the same properties as the Minimum Slow Distance setup.

The Short Part Min. Slow Dist. is used for Minimum Slow Distance when the part length is less than the Short Part Length.

The Very Short Part Min. Slow Dist. is used for Minimum Slow Distance when the part length is less than the Very Short Part Length.

For legacy systems where the user may not have configured the new setups, if the applicable setup has not been configured (Zero Length), the value in the Minimum Slow Distance setting will be used.